new 2.6.30-based firmware

[muromec]

New firmware: http://ezxdev.org/qtopia/firmwares/test1.tar.gz

To flash, use qputusb (muromec's putusb at master - GitHub)

[shantanu]

thanks man

[onix]

I flashed the firmware with qputusb following the steps described here moto-ezx blog: Прошивка test1, but the touchscreen is not working. I have an A1200.

I tried to run ts_test through ssh and it can't find /dev/input/touchscreen0. After I created a symlink from /dev/input/event3 to /dev/input/touchscreen0, ts_test runs ok, but touchscreen still doesn't work in qt. I also tried to restart qtopia by running qpe.sh but still no touchscreen. Also, the screen sometimes flickers with some horizontal lines appearing and dissappearing fast.

[muromec]

>Also, the screen sometimes flickers with some horizontal lines appearing and dissappearing fast.

known

>After I created a symlink from /dev/input/event3 to /dev/input/touchscreen0, ts_test runs ok, but touchscreen still doesn't work in qt.

try following:

uncomment two lines in /etc/defaults/qtopia,

write to /etc/ts.conf:

module_raw ucb1x00
module linear

and to /etc/pointercal:

-15705 -135 14374320 -163 -19273 18373512 51735

[onix]

I've made the changes you mentioned and now it gets input from the touchscreen, but the calibration data is wrong. There is no way to calibrate by using the menus so i had to start the calibration app by ssh:

qcop 'QPE/Application/calibrate' 'raise()'

However, the application doesnt receive input so I can't calibrate the screen. I will keep trying.

[Seby]

New firmware: http://ezxdev.org/qtopia/firmwares/test1.tar.gz

To flash, use qputusb (muromec's putusb at master - GitHub)

Which version of QTopia is it?? It's different from the versions posted here Index of /qtopia/firmwares/a1200/

[onix]

I finally calibrated the touchscreen. It was enough to uncomment the lines in /etc/defaults/qtopia and make no change to /etc/ts.conf. Then I was able to start the calibration app and now the screen works.

@Seby: It is Qtopia 4.3.4 built for a 2.6.30 kernel. Previous versions were using a 2.4 kernel so this one is not so functional.

[Seby]

I finally calibrated the touchscreen. It was enough to uncomment the lines in /etc/defaults/qtopia and make no change to /etc/ts.conf. Then I was able to start the calibration app and now the screen works.

@Seby: It is Qtopia 4.3.4 built for a 2.6.30 kernel. Previous versions were using a 2.4 kernel so this one is not so functional.

I'm not able to install it with qputusb. Can you help me?
Thanks in advance.

[bjk]

whats the power management status of 2.6.30? thanks

[muromec]

>I'm not able to install it with qputusb. Can you help me?

i`l release windows version soon

>whats the power management status of 2.6.30? thanks

pm working