problem using ubuntu telnet to e680i

[doromoji]

Any one success telnet to E680/i via ubuntu 5.1 (Breezy, 2.6.12-9-386)?
I'm not sure whether this Breezy kernel have patch usbnet or not, but
dmesg shows that everything look fine.

I'm plugging the phone in Modem mode
The message seems okay.

[4326952.089000] usb 3-2: new full speed USB device using uhci_hcd and address 2[4326952.243000] usb 3-2: device descriptor read/64, error -71
[4326953.245000] cdc_acm 3-2:1.0: ttyACM0: USB ACM device
[4326953.250000] usbcore: registered new driver cdc_acm
[4326953.250000] drivers/usb/class/cdc-acm.c: v0.23:USB Abstract Control Model driver for USB modems and ISDN adapters

Then I run the script to enable usblan

[4327014.423000] usb 3-2: USB disconnect, address 2
[4327015.092000] usb 3-2: new full speed USB device using uhci_hcd and address 3[4327015.399000] usb0: register usbnet at usb-0000:00:10.2-2, pseudo-MDLM (BLAN) device, 7a:5b:9f:cf:05:30
[4327015.399000] usbcore: registered new driver usbnet

This is my current ifconfig

eth0 Link encap:Ethernet HWaddr 00:0D:61:C0:4B:BB
inet addr:192.168.1.100 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::20d:61ff:fec0:4bbb/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:410431 errors:0 dropped:0 overruns:0 frame:0
TX packets:618620 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:154316335 (147.1 MiB) TX bytes:577457936 (550.7 MiB)
Interrupt:18 Base address:0xe800

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:162722 errors:0 dropped:0 overruns:0 frame:0
TX packets:162722 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:14343201 (13.6 MiB) TX bytes:14343201 (13.6 MiB)

I'm not sure whether I have to ifconfig as ...
sudo ifconfig usb0 169.254.142.1 netmask 255.255.0.0 up
or
sudo ifconfig usb0 192.168.1.2 netmask 255.255.255.0 up

but both give the same error
telnet: Unable to connect to remote host: No route to host


I found some post recommend using LeoPPP. Do I have to use Bluetooth Hub in order to use LeoPPP? I do not have one

[doromoji]

Okay it's work now. Just follow jackie_e680i posting.
http://www.motorolafans.com/index.ph...ewtopic&t=2245

using this command for ifconfig
sudo ifconfig usb0 192.168.1.99
sudo route add -host 192.168.1.2 dev usb0
telnet 192.168.1.2

[domagoj]

using this command for ifconfig
sudo ifconfig usb0 192.168.1.99
sudo route add -host 192.168.1.2 dev usb0
telnet 192.168.1.2

this should be made a sticky for noobs like me.
great one doromoji & jackie. telneted smoothly from ubuntu breezy

[sandman]

No need for sticky....if everything was made a sticky, then what's the point of othe features like search????