MotoRokr E6 keeps on restarting after doing a Master Reset.

[sujoy081]

Hi Guys,
I have been using MotoRokr E6 and I had done a Master Reset after which the phone has been restarting ever since.
It comes to the main screen and restarts infinitely until I remove the battery to shut it down.
However when I don’t insert the SIM card it works fine (does not restart); not sure why that would happen?

I read in some forum that using RadioComm software it is possible to get this resolved, but dont know how? Can anyone guide me on this? Is there any other easier alternative?

Any help in this regard will be appreciated.

Here is some info about my firmware version that my E6 is currently using.

R533_G_11.12.08P
BP: R533_G_11.12.08P
BPFlex: GSZMCAUT677ZH01BDSP
DSP: 63343400
Technology: Quad Band GSM

Also I am using Vodafone Connection, India

Hope all these information helps.

[motomaster]

strange problem.
.08p is a very stable firmware.
reflash it.

[g4m3rz]

had you enabled EDGE before the master reset ?
that is usually the culprit if the phone starts to reboot after a master reset.

start your phone without the SIM card and re enable Edge. it should work fine after that.

[prasannars]

I too got same problem twice. I reflashed it.

[srawat_itpro]

I also got the same problem with my Vodafone connection. I just reflashed with Ahmans .08P firmware and then restarted. The SIM got picked up fine. After this I did the quadband and other hacks.

Rgds
Sandy

[sujoy081]

Sorry for the late response...
Thanks a lot to all you guys for the help.
Especially to g4m3rz you were right, i had EDGE enabled and this was the main reason for the restart, followed as what you mentioned and its working fine.....
You guys are amazing and keep up the good work!!!!!