Join Today
+ Reply to Thread
Results 1 to 6 of 6
  1. Angry setting up motorokr E6 for Airtel GPRS using data cable in Ubuntu 8.04

    Hello friends,

    Kindly help me resolve the problem. I am unable to setup motorokr E6 to use mobile gprs in ubuntu8.04LTS. I am having a PC with following Specification:
    AMD Athlon 2800+ 64 Bit processor with 1 GB RAM & 80GB hard Disk. I Live in India and use airtel connection for internet through mobile. In windows XP it's very easy to setup mobile internet. Earlier i was using Nokia 7610 and configuring it for ubuntu was very easy.

    Just after connecting it to PC through data cable and using the following the command mentioned below i had configured it:

    $ lsusb
    $ sudo /sbin/modprobe usbserial vendor=0x(VID) product=0x(PID)
    $ wvdialconf create

    and then i got the result as:

    Scanning your serial ports for a modem.

    ttyS0<*1>: ATQ0 V1 E1 -- failed with 2400 baud, next try: 9600 baud
    ttyS0<*1>: ATQ0 V1 E1 -- failed with 9600 baud, next try: 115200 baud
    ttyS0<*1>: ATQ0 V1 E1 -- and failed too at 115200, giving up.
    Modem Port Scan<*1>: S1 S2 S3
    WvModem<*1>: Cannot get information for serial port.
    ttyACM0<*1>: ATQ0 V1 E1 -- OK
    ttyACM0<*1>: ATQ0 V1 E1 Z -- OK
    ttyACM0<*1>: ATQ0 V1 E1 S0=0 -- OK
    ttyACM0<*1>: ATQ0 V1 E1 S0=0 &C1 -- OK
    ttyACM0<*1>: ATQ0 V1 E1 S0=0 &C1 &D2 -- OK
    ttyACM0<*1>: ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0 -- OK
    ttyACM0<*1>: Modem Identifier: ATI -- Nokia
    ttyACM0<*1>: Speed 4800: AT -- OK
    ttyACM0<*1>: Speed 9600: AT -- OK
    ttyACM0<*1>: Speed 19200: AT -- OK
    ttyACM0<*1>: Speed 38400: AT -- OK
    ttyACM0<*1>: Speed 57600: AT -- OK
    ttyACM0<*1>: Speed 115200: AT -- OK
    ttyACM0<*1>: Speed 230400: AT -- OK
    ttyACM0<*1>: Speed 460800: AT -- OK
    ttyACM0<*1>: Max speed is 460800; that should be safe.
    ttyACM0<*1>: ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0 -- OK

    Found an USB modem on /dev/ttyACM0.
    Modem configuration written to create.
    ttyACM0<Info>: Speed 460800; init "ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0"

    than edited my Wvdial file like this

    $ sudo gedit /etc/wvdial.conf

    [Dialer Defaults]
    Modem = /dev/ttyACM0
    Init1 = ATZ
    Init2 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
    Stupid Mode = 1
    Modem Type = USB Modem (also tried as Analog Modem)
    Phone = *99#
    ISDN = 0
    Username = A
    Password = B
    Baud = 460800


    save and exit



    than I type this

    $ wvdial

    than this appeared



    --> WvDial: Internet dialer version 1.60
    --> Cannot get information for serial port.
    --> Initializing modem.
    --> Sending: ATZ
    ATZ
    OK
    --> Sending: ATQ0 V1 E1 s0=0 &C1 &D2 +FCLASS=0
    ATQ0 V1 E1 s0=0 &C1 &D2 +FCLASS=0
    OK
    --> Modem initialized.
    --> Sending: ATDT*99#
    --> Waiting for carrier.
    ATDT*99#
    CONNECT
    ~[7f]}#@!}!} } }2}#}$@#}!}$}%\}"}&} }*} } g}%~
    --> Carrier detected. Starting PPP immediately.
    --> Starting pppd at Sun Jun 15 05:17:27 2008
    --> Warning: Could not modify /etc/ppp/pap-secrets: Permission denied
    --> --> PAP (Password Authentication Protocol) may be flaky.
    --> Warning: Could not modify /etc/ppp/chap-secrets: Permission denied
    --> --> CHAP (Challenge Handshake) may be flaky.
    --> Pid of pppd: 6401
    --> Using interface ppp0
    --> pppd: x�[06][08]
    --> pppd: x�[06][08]
    --> pppd: x�[06][08]
    --> pppd: x�[06][08]
    --> local IP address 117.98.4.246
    --> pppd: x�[06][08]
    --> remote IP address 10.6.6.6
    --> pppd: x�[06][08]
    --> primary DNS address 202.56.230.5
    --> pppd: x�[06][08]
    --> secondary DNS address 202.56.240.5
    --> pppd: x�[06][08]
    and net was working.


    But with Motorokr E6 it's not working with these commands.

    Can anyone please assist me how to configure it step by step.

  2. #2
    Join Date
    Mar 2008
    Location
    God's own Country, INDIA.
    Posts
    370

    Default

    I don't see any change in the files even if you are changing the phone.
    Did you set the phone to USB Modem.
    Check if the Modem is detected by using lsusb command


    I connected Internet on Ubuntu 8.04LTS thru E6 with Vodafone Advanced GPRS service.
    http://www.motorolafans.com/forums/e6-general-chat/20643-internet-thru-e6-linux.html
    Last edited by Spidey; 08-13-2008 at 08:16 PM.

  3. #3
    Join Date
    Mar 2008
    Location
    Bangalore, India
    Posts
    64

    Default

    Do we have a linux Modem driver for E6 ??

    Do we have webcam driver for linux too ?

  4. Default

    yeah i have used lsusb command and it detects rockr E6

  5. Default

    could you please tell me the changes to be done in /etc/ppp/option file??

  6. #6

    Default

    Yeah..... Just edit your /etc/ppp/option file
    Add
    :192.168.0.254

    Its works for .....m writing this from E6 and Airtel Gprs


 
+ Reply to Thread

Similar Threads

  1. I want Free Airtel GPRS Trick.
    By wasim2007 in forum E6 General Chat
    Replies: 13
    Last Post: 09-05-2009, 01:55 AM
  2. Charging with data Cable.
    By vinay016 in forum E6 General Chat
    Replies: 10
    Last Post: 07-04-2009, 10:15 AM
  3. Need free airtel gprs
    By kewal.kareliya in forum E6 General Chat
    Replies: 30
    Last Post: 01-29-2009, 02:06 PM
  4. Wtb: Data cable(usb) For Rokr E1
    By J-Villa in forum Garage Sales
    Replies: 0
    Last Post: 11-01-2007, 06:39 PM
  5. A780 replacement data cable
    By Mailman42 in forum A780 General Chat
    Replies: 4
    Last Post: 04-13-2007, 05:31 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Single Sign On provided by vBSSO

Search Engine Optimization by vBSEO 3.6.0 RC 1